| Stereolithography is a computer controlled laser model builder. Looking closely at the photo below, you can see the part of the model that has been formed (sitting on the honeycomb base).
The photo below (taken every 120 seconds) is of the Stereolithography workspace. The bottom right of this photo shows when it was taken. To see the latest photo, refresh the page.
Below is an overview of the stages of the Stereolithography model development.
 |
This a time-lapse photo of a laser contacting the liquid surface, turning it into a solid. |
 |
This is the model created with stereolithography. |
 |
After treatment, the model is ready for use within the wind tunnel. | |